PHẦN A:
1) When installing a manually configured adapter, what information must you know to avoid resource conflicts?
A. IRQ
B. Number of bits
C. Base I/O port address
D. Base Memory address
E. Operating System
2) Which IRQ is usually assigned for the primary IDE hard disk controller?
A. 5
B. 7
C. 9
D. 14
E. 15
3) Which IRQ is assigned to the first serial port?
A. 2
B. 3
C. 4
D. 5
E. 7
4 trang |
Chia sẻ: maiphuongtt | Lượt xem: 2083 | Lượt tải: 1
Bạn đang xem nội dung tài liệu Test for general it knowledge, để tải tài liệu về máy bạn click vào nút DOWNLOAD ở trên
Héi liªn hiÖp thanh niªn viÖt nam
Héi ®ång c¸c nhµ doanh nghiÖp trÎ viÖt nam
***********o0o***********
Test for general it knowledge
Time: 45 minutes
PhÇn A:
1) When installing a manually configured adapter, what information must you know to avoid resource conflicts?
IRQ
Number of bits
Base I/O port address
Base Memory address
Operating System
2) Which IRQ is usually assigned for the primary IDE hard disk controller?
5
7
9
14
15
3) Which IRQ is assigned to the first serial port?
2
3
4
5
7
4) What PC resource is used by a hardware device to save time by writing to memory without the intervention of the CPU?
IRQ
DMA
I/O Address
Base Memory
CMOS
5) A NE2000 Ethernet NIC installed in a workstation with the following configuration -- IRQ=3, I/O=360, MEM=CC000 -- could cause which problem?
No problem, the PC is configured correctly
A potential IRQ conflict with COM1
LPT2
A potential IRQ conflict with COM2
Memory conflict with CC000
6) You have a new TCP/IP network environment. You would like to verify that the TCP/IP configuration has been initialized. What Microsoft Windows NT Utility will give you this information?
PING /IP_Address ALL
IPCONFIG /ALL
PING /IP
IPCONFIG /RELEASE
IPCONFIG /RENEW
7) Other than the controller, how many devices can be installed on the SCSI bus?
4
5
6
7
8
8) What type of cable would you recommend a University client use if they were going to connect two buildings on different campuses? The campuses are approximately 1.2 miles apart, and high bandwidth is a must.
STP
UTP
Coax
RG11
Fiber-optic
9) Thinnet cable can carry a signal up to approximately what distance?
500 meters (about 1,640 feet)
185 meters (about 607 feet)
100 meters (about 328 feet)
2 kilometers (about 6,562 feet)
10) UTP cable can carry a signal up to approximately what distance?
500 meters (about 1,640 feet)
185 meters (about 607 feet)
100 meters (about 328 feet)
2 kilometers (about 6,562 feet)
11) Thinnet is in the RG-58 family. What would its impedance be in ohms?
25
50
100
150
12) What type of wireless transmission would you configure for transferring data from one computer to another rather than communicate among several computers?
Infrared
Point-to-Point
Bridge
Transceiver
13) True or False? NetBEUI is a transport protocol that does not support routing.
True
False
14) Which three selections describe NWLink?
Does not support routing
Microsoft's version of IPX/SPX
A transport protocol
NWLink IPX determines packet type during setup
The IPX protocol is not tied to a particular frame type
15) Name three examples of the OSI Reference Model Network layer protocols.
IPX
TCP
SPX
NetBEUI
IP
16) What is the main function of a routable protocol?
To connect two computers together
To connect a computer and a server together
To provide a path for the packets to flow between nodes
To support multiple LAN to LAN communications among networks
17) When is a default gateway necessary?
When communicating outside your subnet if you have not
configured the route in the local routing table
When connecting to the server
When connecting to PCs in your subnet
18) You need to add resource record to your DNS server. It needs to be an alias for the FTP server. What type of record must you add?
MX
CNAME
MINFO
IN-ADDR-REC
MSEWKS
19) Which utility would you use to locate the NT Server on your network that is receiving the most TCP/IP packets /sec?
Ipconfig
Performance Monitor
Network Monitor
Tracert
20) Which is a function of ARP?
Reports messages and errors regarding packet delivery.
Provides addressing and routing functions.
Obtains hardware addresses.
21) Which address is used to ping your local host?
255.255.255.255
127.0.0.1
131.1.200.200
0.0.0.0
255.255.0.0
22) Which is a function of UDP?
Provides connection oriented packet delivery service.
Provides connectionless packet delivery service.
Obtains hardware addresses required for communicating with a destination host.
Provides addressing and routing functions.
Reports messages and errors regarding packet delivery.
23) Which is a function of ICMP?
Reports messages and errors regarding packet delivery.
Provides addressing and routing functions.
Obtains hardware addressees.
Provides connectionless packet delivery service.
24) Which is a function of TCP?
Reports messages and errors regarding packet delivery
Provides connection-oriented packet delivery service
Obtains hardware addresses required for communicating
with a destination host
Provides addressing and routing functions
PhÇn B:
25) WWW ®îc x©y dùng trªn m« h×nh nµo, u ®iÓm vµ nhîc ®iÓm cña m« h×nh ®ã?
26) Cã mÊy lo¹i Web? Sù kh¸c nhau gi÷a chóng?
27) Giao thøc ®îc sö dông chÝnh trong WWW lµ g× (nªu râ)?
28) C¸c ký m· Javascript, Vbscript ®îc sö dông trªn Web Browser hay Web Server?
29) ASP ch¹y ë ®©u?
30) ISAPI lµ g×?
31) Tãm t¾t ho¹t ®éng cña m« h×nh ASP ?